My dear R.A. and E.D.S. sufferers, I want you too know that I am completely here for you and I care about you. You are not alone, try not to get discouraged, lets figure this out together. I wish I could take all of your pain away, I don't ever want you too hurt. If we can get your joints aligned and supported, maybe we could bring you some relief, I want that so much for you. This splint is similar to my other swan neck splint but this is made with wider silver and its very comfortable. The wider band disperses pressure evenly and it doesn't dig, at least it better not. This Sterling Silver is 3.25mm wide x 1.65mm thick and it makes for a beautifully strong splint. I use one solid piece because you can adjust the angle of the V over and over and it wont break. I am not against using two separate pieces and soldering them together, its just stronger using one piece. If you want to wear this upside down, let me know and I will use two pieces too make sure its comfortable on the top of your joint. If you need a splint for your dip joint, email me and I will probably recommend this design but in a little bit lighter silver. I can add lateral supports on either or both sides of this splint, let me know if you think its something we need. These splints work great for swan neck, hypermobility and can work for hammer and mallet finger. It helps keep your joint aligned and supported and will hopefully allow your joint to heal if at all possible. *** Sizing *** - I can make this for you using the ring size of your joint. If I can also get the smaller size of your forefinger right before the joint towards your fingernail, that would help me to get this right for you. If we get the size wrong, I will take it back and resize it, you have me and I take care of you no matter what.
Handmade Sterling Silver Wide Band Swan Neck Splint - Rheumatoid Arthritis Splint - Hypermobility - EDS Splint Ring Handmade - WINK08TUB